CNC Gearbox V2 9mm QSC (Retro Arms)

V2 tüüpi Gearbox tootjalt Retro Arms.

Gearbox on tehtud ühest tervest alumiinium plokist CNC tehnoloogiaga.

• Materjal: Aircraft Aluminum (Dural) EN AW 7075 T651 mis on tugevam (590MPa), kui tavaline teras (390MPa). Tänu kasutatud materjalidele, on tegemist ühe parima turul oleva gearboxiga.
• Bushing/Bearing augud: 9mm
• Komplekti kuuluvad kruvid ja vedrujuht
• Kiire vedruvahetus
• Anodeeritud
• Kaal: 135g

Mõningad kasulikud omadused ja soovitused tootjalt (inglise keeles):

• Spring holders have grooves, so the springs for tapped plate and trigger switch will not jump off.
• Added groove for safety lever, so it will hold during installation.
• Added groove for trigger spring, for better fitting.
• AOE control hole.
• Sockets for bushings/bearings have smaller diameter about -0,02mm (8,98mm), for non-overturning the bushings during installation. The socket edges are cutted down for better installation.
• We enhanced grooves for wiring for 1mm, you can now use wirings with 2,5mm diameter.
• Added protecting edge for wiring against the motor.
• All threads are now shaped instead of cutted for better strength.
• Both of the gearbox parts are centered by milled grooves and edges.
• Added hole for releasing anti-reverse latch.
• For better durability, we added more material around cylinder head part of the gearbox, this was the most critical part and we added 100% more material where is huge radius.
• Added groove for anti-reversal latch spring, so it will not jump off.
• Outer edges are now cutted off.
• You can find what type of sockets gearbox have on the outside part of the gearbox (8mm or 9mm).
• Space for trigger switch is designed for compatibility with trigger switches, trigger units from common manufacturers for example: Gate, etc

Kokku kruvimisel kasutada 1Nm jõudu. Puudub vajadus kruvisi üle pingutada, kuna see lõhub ka keermed. Võib kasutada ka keermeliimi.

Mitte kasutada MAXX silindripead